My electronics are definitely up to the task of handling a "higher end" cartridge.
The preamp is a $5k custom designed all tube unit with "tele's", Mullards and other very old nos. The power amp is a class A triode 300B push pull that is really quite extraordinary. Arm is a Moerch DP6 on a Merrill Heriloom. I believe the Glider works because it is matching the built in Jensen 347 step-up trannie perfectly as well as the arm. I have had a high output Glider sounding like you have experienced but switching to a low is REALLY very good now and my system is very neutral. Sitting as close as I do, brightness would drive me crazy. I have tried an Allaerts MC1B and it was as superb as has been noted except for a degree of thinness in the midbass/lower mids. I think that my step-up at 80 ohms is suspect as others have actually reported that 40 ohms is perfect in a step-up although 100 ohms for active is spec. My armtube is also suspect as a heavier tube has been recommended. Do any of you have recommendations on step-up trannie impedance for the MC1B?
The preamp is a $5k custom designed all tube unit with "tele's", Mullards and other very old nos. The power amp is a class A triode 300B push pull that is really quite extraordinary. Arm is a Moerch DP6 on a Merrill Heriloom. I believe the Glider works because it is matching the built in Jensen 347 step-up trannie perfectly as well as the arm. I have had a high output Glider sounding like you have experienced but switching to a low is REALLY very good now and my system is very neutral. Sitting as close as I do, brightness would drive me crazy. I have tried an Allaerts MC1B and it was as superb as has been noted except for a degree of thinness in the midbass/lower mids. I think that my step-up at 80 ohms is suspect as others have actually reported that 40 ohms is perfect in a step-up although 100 ohms for active is spec. My armtube is also suspect as a heavier tube has been recommended. Do any of you have recommendations on step-up trannie impedance for the MC1B?