2. digital
  3. 194393-128327

Any Legacy Wavelet owners experiencing room correction issues

I just upgraded to the Wavelet 2 from an older v1 and I cannot get the room correction to work properly. I get errors during the calculations. (See image below.)
I am not big fan of how the correction process works but I have had excellent results in the past.
I thought it was a network issue on my end but nothing I did changed the outcome. I took it to friend's house just be sure but got the same errors.
I have tried different amps, cables, speakers, bypassing AC line conditioners and noise filters and power cords to no avail. I have been working with the guys at Legacy and have swapped out several units with them and all do the same thing once they are hooked up to my system even though they worked fine at their shop prior. (their service and cooperation has been nothing less than stellar BTW!) They are working with Bohmer to see if something changed on their end.

So... just wondering if any other Wavelet owners have experienced these issues.
 

tkn42
tkn42 OP
7 posts
 

Yes, it is communicating with the server and sending information back. 

Sorry, I see that I did not post the image correctly.

Here is the information the server is returning:

Starting Room Correction calculations
Loading microphone calibration data.
# Done!
Processing left channel measurement data.
# Done!
Processing right channel measurement data.
# Done!
Calculating Room Correction for left channel.
0 : Calculating Room-Correction, pass 1:1, please wait...
Room-Correction warning
The detected upper cut off frequency in the measuement data is 883 Hz, it is likely to low for the Room-Correction algorithm to generate a reliable correction
1 : Calculating Room-Correction, pass 2:2, please wait...
1 : Calculating Room-Correction, pass 4:1, please wait...
# Done!
Calculating Room Correction for right channel.
0 : Calculating Room-Correction, pass 1:1, please wait...
Room-Correction warning
The detected upper cut off frequency in the measuement data is 1245 Hz, it is likely to low for the Room-Correction algorithm to generate a reliable correction
1 : Calculating Room-Correction, pass 1:2, please wait...
1 : Calculating Room-Correction, pass 2:2, please wait...
1 : Calculating Room-Correction, pass 4:1, please wait...
# Done!
Performing gain adjustments.
# Done!
Room Correction calculations ended successfully!
#####  #####  #####  #####

csmgolf
908 posts
 

I sent you a couple of PMs describing my experience with something similar and how it was resolved after I got my Wavelet 2.

tkn42 OP
7 posts
 

Just to close this out... It was server issues and all resolved!

fthompson251's avatar
fthompson251
528 posts
 

@tkn42   Glad to hear this, my Wavelet has been humming along for about 2 years now. I use it as the preamp/DSP unit with an outboard DAC. Focus XD's.

More to discover