Amplifier recommendations for 86 dB Sensitivity Speakers

Hi,

I’m considering a pair of Technics SB-G90M2, they have good specifications on paper; however, my only concern would be their 86 dB sensitivity. 

My current amplifier is Cayin A100t, which according to its specs, outputs 70 watts into 8ohms. the Technics are 4 Ohms; so, I assume my Amp could deliver 100-140 Watts into 4 Ohms. Unfortunately, I couldn’t find more accurate information about my amplifier, and it only shows the output power at 8 Ohms equipped with KT-88 output tubes (mine came with EL-34s), therefore, it’s unclear what the real output powerat 4 ohms is.

Wondering if this tube amplifier would be a good match for these more demanding 86 dB speakers? I’m aware of impendence fluctuations and I know the Amp can drive them just fine, but I am not sure if 100 watt per channel -assuming that’s what my Amp can deliver into 4 Ohms- would be enough for these speakers to make them sound as intended, meaning, good sound quality.

(I don’t nor am planning to listen at high volume but have a larger room with high ceilings).

Below are the specs.

Many thanks,

Technics SB-G90M2 Speakers 

• Type: 3-way floorstanding speaker with bass reflex
• Woofer: 2 x 16 cm
• Midrange: 16 cm
• Tweeter: 2.5 cm
• Sensitivity: 86 dB
• Impedance: 4 ohms
• Frequency range: 33 Hz – 90 kHz (-10 dB)
• Crossover frequencies: 500 Hz, 3400 Hz
• Maximum power handling: 200 W
• Recommended amplifier power: 40-200 W
• Dimensions and weight: 111.4 x 29.2 x 36.6 cm / 35 kg

Cayin A100T Integrated Tube Amplifier 

Power output: 70 watts per channel into 8Ω (stereo)

Frequency response: 10Hz to 65kHz

Total harmonic distortion: 1%

Input sensitivity: 480mV (line)

Signal to noise ratio: 89dB (line)

Speaker load impedance: 4Ω to 8Ω

Valve complement: 8 x KT88, 2 x 12AU7, 2 x 6CG7, 1 x 12AX7

Dimensions: 440 x 210 x 397mm

Weight: 29kg