As per Stereophile, the Benchmark amp is super quiet. The model name escapes me but it was reviewed maybe two years ago and Atkinson was shocked by how quiet it measured.
Amplifier For Compression Drivers In A Tri-Amp Setup...?
Hello all. Long time lurker (creeper?), first time poster. Thought you fine folks may very well be the best suited to help with the following quandary so here we are.
I've come across a pair of speakers which require tri-amping and looking very much forward to making them sing again. Each driver (or pair) has it's own input and no internal network. They originally came with an active analog crossover but that piece has been lost in the fray so I'm attempting a work-around here. I have a 4x200w amplifier (Theta Dread) to run the woofers and mids but am still uncertain on where to go powering the compression drivers (EV N/DYM1).
The compression drivers have a sensitivity of 112dB/1w so a quiet amp is an absolute must. We're figuring with the sensitivity of the mids being roughly 87dB (Dynaudio 15w75 x2 per speaker, wired in parallel) that we should be somewhere around 50w-75w on the highs with 200w each on the mids and woofers. The woofers are an unknown as I have yet to measure them, a custom job by Tom Holman.
Any recommendations for an amplifier in that power range which is quiet, has a smooth upper frequency signature, is hopefully a balanced design, and can be had for around $2,000 or less on the used market? I am not against an older model needing a recap as I do have a fair bit of experience with the iron.
Thank you all.
Best,
Travis
I've come across a pair of speakers which require tri-amping and looking very much forward to making them sing again. Each driver (or pair) has it's own input and no internal network. They originally came with an active analog crossover but that piece has been lost in the fray so I'm attempting a work-around here. I have a 4x200w amplifier (Theta Dread) to run the woofers and mids but am still uncertain on where to go powering the compression drivers (EV N/DYM1).
The compression drivers have a sensitivity of 112dB/1w so a quiet amp is an absolute must. We're figuring with the sensitivity of the mids being roughly 87dB (Dynaudio 15w75 x2 per speaker, wired in parallel) that we should be somewhere around 50w-75w on the highs with 200w each on the mids and woofers. The woofers are an unknown as I have yet to measure them, a custom job by Tom Holman.
Any recommendations for an amplifier in that power range which is quiet, has a smooth upper frequency signature, is hopefully a balanced design, and can be had for around $2,000 or less on the used market? I am not against an older model needing a recap as I do have a fair bit of experience with the iron.
Thank you all.
Best,
Travis
- ...
- 3 posts total
- 3 posts total