Amplifier advice from Ohm Walsh 100 Mk. II owners


I am awaiting a pair of Ohm Walsh 100 Mk. II speakers. My current system uses a Rega Brio 3. (49 watts at into 8 ohms, 64 watts into 4 ohms) I suspect it may fall short with the Ohms.

The room is around 30x20, with a cathedral ceiling that extends up to 16 feet. The system is along the long wall, and most listening is done with 8-10 feet.

The amplifiers under consideration are:

Rogue Cronus Magnum (90 watts, Tube)
Wyred4Sound STI500 (250 watts into 8 ohms, 550 watts into 4 ohms, Class D)
Quad 99/909 (140 watts into 8 ohms, 250 watts into 4 ohms, Solid State)

Any input/guidance from other Ohm Walsh owners, specifically Ohm Walsh 100 Mk. II owners past and present, would be greatly appreciated.
anonymoustao

Showing 4 responses by martykl

If you like to listen loud, you'll need more juice than the Brio can supply. The Rogue might or might not work out well, but I suspect the other 2 would be fine.

In my 15 X 23 room (similar ceiling), the 122 WPC ARC VT130SE does fine for my needs, but I'm not sure how much further I'd want to push it.

200+ SS WPC would probably be more than enough.

Good Luck

Marty
The Hibachis work well with Ohm 100s and are dirt cheap right now ($650/pr direct from TAD, last I looked). I can assure you from personal experience that this combo works well. However, the TADs are on the warmish side for SS amps, and they're not the last word in "transparency", so - if that's your thing - they may leave you a little short of the mark. They're also slightly quirky on the layout and - tho nicely finished - they're definitely not "jewelry".

If you tend to listen "to" (ratther than "thru") the music, you'll probably love 'em.

Good Luck,

Marty
Incidentally, if you use a single source, the current version (I think) offers attenuation - so you (technically) don't need a preamp (tho you might still want one).

You might want to check w/TAD to be sure on this point.

Marty