If you have the arm in front of you, you'll see the hole is not perpendicular to the cue lever cylinder along the mounting platform. Because it's set back, it's a PIA to adjust. With the arm mounted on a table,.it might be impossible.
Also, the headshell lifter is ridiculous, but this is easily replaced with a ProJect (or any) replacement part. You might have to snip off half the piece due to the central headshell protrusion. Other than those minor faults, the arm has a lot going for it, most notably the one piece titanium construction. Eff mass is in the 11g range, but it performs more like a low mass arm with med/high cu cartridges, that is in terms of resultant transient response.. High mass arms tend to sound sluggish with those carts, IMO.
