Alpha-Core Goertz speaker cables

Thanks to all. Al, I was hoping you would reply, so thanks to you as well. I understand better now and think it is an interesting approach but it may be "an answer in search of a question".

FWIW, I have used both the MI 2's and MI 3's with Alpha-Core's external RC networks (zobel's) and have found them to be the best sounding speaker cables I've ever used. I do suggest you do a search here on Audiogon, there was quite a bit of posting done on them, some of the most interesting by Sean. Better yet, give them a try,
Alpha-Core has a generous free trial policy, don't forget to ask for the RC networks.

I've been using the MI3 speaker cables for many years with out any amp problems, but I recently purchased new speakers with a tri-wire connectons on back. I have the opportunity to purchase another set of (used) MI3 cables, but I wonder if doubling the amount of these cables will cause my amp problems. Anyone out there had experience with this? I've had my cables since 1997 so I don't know what I did with the networks or if I ever had them.

Gkp, without knowing any of the details of your system and setup, particularly what amplifier you are using and how long the cables are, I'd have to say that without a Zobel it would be a significant concern.

The MI3, along with the AG3, have the highest capacitance of any of the Goertz cables, at 1500 pf/foot. From the perspective of the amplifier, using a biwire pair will double that.

Factors that would increase the likelihood of a problem are long cable length, the amplifier being solid state, the amplifier having wide bandwidth, and the amplifier using relatively large amounts of feedback.

Regards,
-- Al

Thanks for your insight, Al. At this point I will probably pass on the extra set of cables and just get better jumpers. But if the system matters that much, here you are: Tube amp--AudioPrism Debut Mk1. It is very flexible in that the output can be set to 2,4,6, or 8 ohms, and the feedback has settings for each of those outputs. Right now I'm using the 4 ohm output setting and the '6' feedback setting. Only problem is that the bottom panel must be removed to make any changes. I think it has 16 screws!

My speakers are the Spendor SP 9/1. They have a 5.6 minimum impedance, and are rated at 91dB sensitivity. The MI3 cables are 8 feet long.

So, good or bad match for the bi-wire option?

Thanks again.