Not even taking into account inductive reactance, resistance will be substantial. Gauge 16 is about 4mohm/ft making 0.8ohm per 2x100ft. I would keep it as short as possible and use thicker wire. Coiling unused cable would make no difference, but I would stay as short as possible.
With thicker wire you might get another problem - resistance change because of skin effect. 12 gauge copper wire has about 1/3 higher resistance at 20kHz (0.4ohm/2x100ft) than at 20Hz (0.3ohm/2x100ft). It might not be important, since most speakers are inductive at high frequencies - meaning their impedance gets way higher.
Advice on Speaker Wiring - Larger Advent w. McIntosh MA6500 Amplifier / Speaker Settings
I recently connected a second set of Larger Advent speakers to my McIntosh MA6500 Amplifier. They are in another room, about 70 feet away.
I used 16 gauge Rocketfish speaker wire, that I ran down under the house in the crawl space. The speaker wire came in a 100ft roll, so I have about 30 ft left over.
I'm wondering if I should cut the speaker wire, so that the wire is the shortest distance possible between the amp and the speaker? Or can I leave the full 100ft length with the excess spooled up behind the HiFi rack, in case I ever want to move the system in the same room?
Will there be any audible difference in the sound between running the speaker wire 70 ft vs 100 ft?
Also, the Larger Advents have settings on the back to switch between Normal, Decrease and Extended. I have them set on Normal. Any information on what the difference is between these settings?
Thanks in advance!
Paul in Astoria
- ...
- 11 posts total
Wire on a roll is also called an inductor.
Just fold the extra back and forth under the floor if you don't want to cut it short.
Also, imo that is far too long a run for 16ga wire, and miles too long for the cheap zip chord you used. Belden wire is very affordable from Bluejeans cables. I had zip chord running to surrounds in my HT that I replaced with Belden wire and heard an immediate difference even with cheap speakers and an AVR.
Yeah, I know ASR says it's fine, it's not... |
I don't know what you are referring to on Amazon. https://www.bluejeanscable.com/store/speaker/index.htm They buy it on huge rolls, it meets codes for in wall installation and can be run for very long runs. Get it from the source, it is prolly cheaper and no reason to give a 3rd party your money. |
- 11 posts total