So there.
Accuphase E650 XLR Input issues
I'm asking on behalf of a dear friend, he has an Accuphase E650 which was used on RCA input without any issues, recently with an upgrade of the source, XLR was chose as the preferred connection.
It works fine initially, however just after few days, the left speaker start to sounded noticeably softer than the right, sometimes it normalise sometimes it stay on as is for long period of time, these were done as isolation steps:
- Continue to use RCA input, works consistently
- Swap left / right XLR input, still the left speaker softer noticeably
- Swap different DAC with XLR output, still the same behavior, left speaker softer noticeably
- Tried different XLR cables, still the same behavior, left speaker softer noticeably
- Tried both the XLR preamp input (CD-in, and Balance-in), same behavior, left speaker softer noticeably
Ran out of options, the challenges was the amp was purchased from an oversea distributor, getting local dealer support can be a hit and miss, trying to post this up to see if anyone ran into such issue before and also seeks some opinion.
- ...
- 21 posts total
i just want to be clear and say that i have tremendous respect and liking for accuphase gear which i have owned on several occasions in the past it is wonderful gear, so beautifully built and sound quality to die for my initial response to the op was specifically on the narrow topic of xlr input implementation in their relatively recent pieces my experience otherwise with accuphase amps have been wonderful, and they have been utterly reliable and absolutely built to last a lifetime |
Given the diagnostics performed and assuming that ‘softer’ means lower volume, I assume that either pin 2 or 3 (in any case, not the ground pin) of the left XLR connector in the amp (not the cable) are suffering from a ‘cold’ soldering contact, or more precisely, a hairline fissure (this would explain random ‘recovery’). Have a technician take a look at the XLR input of the amp. Good luck |
@aschuh hopefully that the case so it's not too big of an issue, will seek for some tech help |
@paradis Here is simplest method to check if balanced input functions properly: 1) need to make custom “debug” RCA - to XLR cable, where RCA hot pin to pin 2 + 3 at XLR, shorted together. Shield / RCA GND as ussual goes to XLR pin 1. 2) using this cable, connect source to left and after to right Accuphase balanced input, and check output. 3) faulty balanced input with this “debug” RCA-XLR cable, will sound significantly louder. Ideally balanced input should not produce any sound, good pre/amp will produce signal at -40dB or lower level. |
- 21 posts total