Accuphase E-260 Voltage Conversion (100V to 230V)

Hi @imhififan 

i just have a question regarding the conversion on the e-270. 
If following the voltage conversion table to 120v from the e-260 service manual, and apply the rewiring on the e-270, it turns out that pin 2 should be black and pin 4 should be orange. 
as both cables are 100v, I’m wondering if there would be any difference from your proposed cabling scheme above?

Thanks so much. 

If following the voltage conversion table to 120v from the e-260 service manual, and apply the rewiring on the e-270, it turns out that pin 2 should be black and pin 4 should be orange.

@jgore 

Pins 2 and 4 are not connected to any part of the circuit, they are there to house unused wires. So it doesn’t matter if the black and orange wires are on pin 2 or pin 4.

Connect the yellow and brown wires to pin 3 to set the voltage to 120V.

Hope this helps.

Thanks so much @imhififan 

does it matter which wires go on top and on the bottom of pin 3 ? 
also, is it possible to use my synergistic research purple fuse on the e-270 ? 
the fuse is currently used on a 120b Hegel H190 and it’s rated at 10AT ( slow blow)

Thanks again for your support  

does it matter which wires go on top and on the bottom of pin 3 ? 

It doesn’t matter.

the fuse is currently used on a 120b Hegel H190 and it’s rated at 10AT ( slow blow)

IIRC, the fuse in the E-270 is 5A slow blow, your 10A SR fuse will not provide desired protection.

Thank you @imhififan , appreciate it.