Thank you all for your 'spirited' commentary in response to my query. My intent was not to single out the producer of the speakers for several reasons, namely that the junction of which I speak is similar to those used by many manufacturers, both high end and budget, and secondly because the producer/designer of these speakers is a company whom I respect highly and I know them to make some of the best products in the world.
It was due to the aforementioned second point that I actually anticipated somebody informing me that this last junction was not, in fact, a critical one and for that reason such a system (as previously described) of connecting the wire at the internal wire/driver interface was more than acceptable. I anticipated this despite it not adhering to solid, deductive logic (although I aim to avoid arguments of logic in this forum as they so often are devoid of the one criteria that should be utilized in such debates above all others - mathematics).
The speakers are made by Audio Note, and since acquiring my first pair of their speakers, a second-hand set of AX-2's purchased on Audiogon, I have never looked back, having owned a number of their amps, preamps, and speakers, from AX2's up through AN/E's. Nothing matches the sound, and I have no reason to second-guess the practices of such an industry juggernaut, yet given the importance put upon connections, solder joints, gauge of wire, braiding and dielectric of wire, etc., it seems curious to me that the final leg of the signal's journey would be through a solder joint onto a stamped rivet attached to a small terminal board that can become loose and rickety, which then leads out into two thin wires that attach to the actual woofer. A picture of this can be seen here: Photos of woofer terminals
Again, I aim not to raise the ire of fellow owners, nor that of Mr. Qvorptrup, as what I seek here is clarification of how this connection can be so seemingly modest, while the rest of the chain is scrutinized so heavily it can leave one ready to throw out their entire system if their RCA terminations are anything shy of diamond-bedecked and gold-gilded.
Thank you.
It was due to the aforementioned second point that I actually anticipated somebody informing me that this last junction was not, in fact, a critical one and for that reason such a system (as previously described) of connecting the wire at the internal wire/driver interface was more than acceptable. I anticipated this despite it not adhering to solid, deductive logic (although I aim to avoid arguments of logic in this forum as they so often are devoid of the one criteria that should be utilized in such debates above all others - mathematics).
The speakers are made by Audio Note, and since acquiring my first pair of their speakers, a second-hand set of AX-2's purchased on Audiogon, I have never looked back, having owned a number of their amps, preamps, and speakers, from AX2's up through AN/E's. Nothing matches the sound, and I have no reason to second-guess the practices of such an industry juggernaut, yet given the importance put upon connections, solder joints, gauge of wire, braiding and dielectric of wire, etc., it seems curious to me that the final leg of the signal's journey would be through a solder joint onto a stamped rivet attached to a small terminal board that can become loose and rickety, which then leads out into two thin wires that attach to the actual woofer. A picture of this can be seen here: Photos of woofer terminals
Again, I aim not to raise the ire of fellow owners, nor that of Mr. Qvorptrup, as what I seek here is clarification of how this connection can be so seemingly modest, while the rest of the chain is scrutinized so heavily it can leave one ready to throw out their entire system if their RCA terminations are anything shy of diamond-bedecked and gold-gilded.
Thank you.