Geez, a lot of academic mumbo jumbo in this thread. I have spent countless hours listening to full sized speakers with a -3db point between 22 Hz and 40 Hz. Without question, the lower extension speakers have dramatically out performed over enough of my listening list that it is important. Of course, sometimes 40 Hz is all you need, but there is plenty of music that plums the lower depth. I have had Revel Salons, Thiel CS5s and CS7.2s in my listening room at the same time to compare along with less bass proficient speakers to compare. It makes a significant difference.
A full range speaker?
Many claim to be, but how many can handle a full orchestra’s range?
That range is from 26hz to around 12khz including harmonics, but the speakers that can go that low are few and far between. That is a shame, since the grand piano, one of the center points of many orchestral and symphonic performances, needs that lower range to produce a low A fully, however little that key is used.
I used to think it was 32hz, which would handle a Hammond B-3’s full keyboard, so cover most of the musical instruments range, but since having subs have realized how much I am missing without those going down to 25hz with no db’s down.
What would you set as the lower limit of music reproduction for a speaker to be called full range?
I’m asking you to consider that point where that measurement is -0db’s, which is always different from published spec's.
That range is from 26hz to around 12khz including harmonics, but the speakers that can go that low are few and far between. That is a shame, since the grand piano, one of the center points of many orchestral and symphonic performances, needs that lower range to produce a low A fully, however little that key is used.
I used to think it was 32hz, which would handle a Hammond B-3’s full keyboard, so cover most of the musical instruments range, but since having subs have realized how much I am missing without those going down to 25hz with no db’s down.
What would you set as the lower limit of music reproduction for a speaker to be called full range?
I’m asking you to consider that point where that measurement is -0db’s, which is always different from published spec's.