2. tech-talk
  3. 1102828324

9 gauge vs 12 gauge Jumper of same brand cable

Hi, I am contemplating of getting same brand cable's Jumper to replace the stock jumper of my spkr. My spkr cable is Analysis Plus Oval 9 (9 gauge ). I am wondering should I go for AP Oval 12-jumper(12 gauge) which is not as THICK and easier to attach to spkr binding post , or get
the Oval 9-Jumper (9 gauge)? Would there be any significant sonic differences between using them ?? (would Oval 9 jumper sounding better than Oval 12 ? especially on Bass region ???)
Your opinion,explaination and suggestions is highly appreciated and thanks in advance
Simon
simonleemd
simonleemd OP
29 posts
 
Thanks again ,S23chang. for such illustrative and helpful informations.
On setup D - is it 2-pair of identical cable with stacking up the spades on both end with the jumper remained in place ? or having the 4 spades connected to Upper and Lower spkr binding post / while only 2 spades connected to Amp end (jumper removed)
I really need your confirmation ,please
Thanks
Simon
s23chang
619 posts
 
In setup D, the jumper brass plate was not in the picture.
Yes, two pairs of identical cable running parallel.
On the amp side, there is only one set of output, we use banana plugs for the convenience to stack them.
On the speaker side, we run bare wire to each upper and lower binding post.
simonleemd OP
29 posts
 
Hi,S23chang .
just for my better understanding- Is the Setup D the exact same as "Discrete Biwiring"?
Thanks
Simon
s23chang
619 posts
 
YES. Discrete Biwiring is the setup D
More to discover