2. analog
  3. 1139506417

60 cycle hum

I'm running a Rega P5 with outboard PSU into a Yamaha receiver with an internal phono stage. I hear no extraneous noise with the needle off the record 'til the volume control hits 12:00 - it then increases as the volume increases.

Playing records, the Exact cartridge has such a high output that I routinely listen between 9:00 and 10:00 and get plenty of volume...

Is the hum a problem or am I looking for an excuse to buy an add on phono stage?

BTW I seem to recall the same "problem" with an old HK receiver and a Denon TT with a Grado cart........but I thought it was Grado hum and when I swapped the cartridge for an Ortofon it was still there, but only at very high, not listening, volumes.

any comments would be appreciated.
joe_in_seattle
vinyladct
7 posts
 
Sorry for the delay, been away for a few days.

If it's below the noise floor of the turntable and only audible when the volume pot is pushed past 12:00 - honestly, I wouldn't worry about it. I can't say 100% without hearing it in person - but it sounds like normal noise levels for your setup.

The number of coil windings in those high output cartridges are going to pick up some stray noise. Every Goldring (6mv) or Rega (7mv) cartridge I've ever run has had it.

You can drive yourself nuts tinkering with all the nuances of analog - your best bet is to just sit back and enjoy it as long as nothing is glaringly wrong.
joe_in_seattle OP
114 posts
 
Thanks, Vinyladct..........it is well below any level I could stand. If I get it too loud my parrot screams - he wants me to save my hearing. (and his)

The reason I bought the Rega in the first place is set it and forget it operation.

I can even tell in the next room if it's a cd or an lp playing.................and those .50 and dollar finds!

Thanks everyone for input and help.
vinyladct
7 posts
 
The Exact is a fine cartridge, especially for jazz and rock - don't let anyone tell you otherwise. It's especially nice when you don't have an external phono-stage due to its unusually high output.

Enjoy!
miner42
709 posts
 
I was told to move my TTPSU as far as possible from my P5 TT. The power cord from the PSU to the TT is about 4 ft. long which is how far they are apart. I first had my P5 sitting atop my amp - did not work; got feed back at med. volume. Now I have it sitting on top of my proj TV. So far so good.
More to discover