12v Trigger connection for Pass Labs X150.5


Hi all,

need some advice here, esp from Pass Labs amp users. The 12V trigger of the X150.5 has two binding posts (Red and Black) just like the speaker outputs, that means it takes only spades input.

some of the pre-amp with 12V trigger has only a single 1/8" output. how to connect it to the X150.5? 1/8" --> Spades? to red or black binding post?

i'm confused. pls assist.

Thank you.
rc5al
Spades are not absolutely necessary.

One alternative is to cut the plug off, strip a small amount of insulation, and connect the bare wire to the terminals.
one more qns.

the 12V trigger terminals of the X150.5 draws current of about 5mA. can i supply a output of 12V and 2.5A to it? will it cause any damages to the amp?

Thanks
It doesn't matter how many amps the 12 volt supply CAN produce. What you draw will only be 5 ma.