viajero5000
Responses from viajero5000
| Wyetech Opal preamp Hi - I have an Opal. Haven't felt the need to change it since I purchased it a few years ago, it's very good. Can't comment on the Lamm. | |
| Powering Infinity Prelude MTS Winslowst, I've just logged on to AG after a very long time, but FWIW I have never found the Preludes to be bright in any way - they work very well with my tube amps, neutral but not at the expense of musicality. The problems I've had are a buzzin... | |
| Powering Infinity Prelude MTS I don't believe so, but I've never tried. | |
| Powering Infinity Prelude MTS Hi Joysjane, my understanding is also the same as Jburidan's... feeding the signal from the amp does not cause the sub-woofer amps to be over-ridden by the external amp, the subs are always self powered. I'm guessing what you may be hearing is the... | |
| Powering Infinity Prelude MTS Those Tannoys are studio monitors, correct? They look huge. I also own a pair of studio monitors, the PMC MB2s, and no home speaker I've owned matches their lack of compression and clarity. Unfortunately they require a good few hundred watts of cl... | |
| Powering Infinity Prelude MTS Thanks, I will check the bases and see if I can source the screw on spikes. Speaking of SET amp friendly speakers, have you compared these by any chance to Avantgarde or similar horn speakers? Any thoughts? | |
| Powering Infinity Prelude MTS Hi Jburidan, I didn't know that, thanks for the heads up. Will try positioning them as advised. No, I'm not the first owner, I bought these last year (or was it the year before?) for a second set up used but in good condition. I was looking for a ... | |
| Powering Infinity Prelude MTS I have done very little experimentation thus far with these speakers as I haven't had the chance to use them much. I originally set them up almost face forward and about three feet from the back wall. I later tried toeing them in significantly and... | |
| Powering Infinity Prelude MTS Hi Joysjane, thanks for the heads up re the woofer and tweeter. I don't think it's an amplification issue as I can hear a slight scraping sound when I push the particular mid-range and woofer manually with my thumb(with no music playing) to simula... | |
| Powering Infinity Prelude MTS I connect the entire system direct to the amplifiers (Wyetech Labs Topaz SET mono-blocks or Bryston 14B-SST2 s/s amp). Nice speakers, but one of the mid-range drivers and a tower woofer has started buzzing with certain types of music... hope I'll ... | |
| has anyone else heard the wyetech ruby mono block Pavpet,Which speakers did you hear the Rubies with? | |
| Bryston 28B SST I have a 14B-SST2 (latest transformer and all 'trickle down' improvements of the 28) and a 14B-ST (which is the first of the SST design amps). The 14B-SST2 has a clear, neutral character with noticeably tauter/extended top end and a more organised... | |
| pass labs 350.5 vs bryston 7 bsst to drive b&w 802 Bd223, you're right, the 7B-SST's run cooler than the 14B-SST.... I think Mordante is confusing the previous 14B-*ST* as being better than the previous 7B-*ST* monos... the 14B-ST was the first of the amps that used the technology used in the curr... | |
| Need feedback from Bryston amp owners I own a 4B ST; great value for money product. Great low end, good dynamics,neutral without being cold, built to last a life time, and a perfect match for my PMC speakers. However you need careful pre-amp pairing to smoothen out the upper mids/ low... |