ubersujith
Responses from ubersujith
| Madrigal Proceed PAV Schematics Wow, thanks again. I will pass this info along. Unfortunately, without the schematics and electrical signal paths and values, the tech says it would be expensive were he to engage in trial and error, and he couldn't guarantee success. I'm going to... | |
| Madrigal Proceed PAV Schematics A local shop is doing the work. Not retail, just a repair shop fixing hi-fi and musical instruments, who are attached to a practice studio. They have done good work for me in the past, and I trust them. | |
| Madrigal Proceed PAV Schematics Wow! Thanks so much, auxinput. I'll let you know how we get on. I'll have to price out recapping the entire board and then make a decision, but I would love to. This is by far, the best sounding pre-amp I own. By which I mean transparent. I didn't... | |
| Vandersteen, Audio Note, and Resistance Thanks all. I tried both taps, I think the 8ohm one sounded a tad better. And surprisingly, amp was not terribly "disappointing" as ozzy62 and I thought. I read on Vandee's website that Richard thinks that 1c should be fine with 15wpc from tubes. | |
| Vandersteen, Audio Note, and Resistance Just saw some more youtube vids. Apparently, I need to be concerned about over-heating the output transformer if I use the 8 ohm posts. | |
| Attenuater Autonomy? Thanks, Al and George.Upon closer inspection of the manual, I think your are correct George. On the Proceed PAV, I can adjust the input signal from each source, not lower the attenuated range of output signal. AND, I might be able to do this witho... | |
| Biwiring an Amp into a Single-wired Speaker? Hey Al, I just set you up for another edifying reply over in the amps pre-amps forum. Cheers. | |
| Biwiring an Amp into a Single-wired Speaker? Wow, Al, thanks for this informative and well-written response. One follow up question: I have 4 fancy WBT connectors at the speaker end of my biwire cable. Would you recommend moving them to the amp end, or use 4 lesser connectors at the amp end,... | |
| Anybody still use a Hegeman Hapi 2? I have one. I have used it as a pre, off and on in my second system, and now I am going to use it as a dedicated phono stage. I will report back soon... |