svampebob
Responses from svampebob
| Duelund conversion to DIY Helix Geometry Cabling Hi good folks, I use double neotech SOCT-14 in tube in helix config for speaker wires for my bass/mid drivers. I use a great active crossover/eq so the frequency response does not matter too much as I can just adjust everything appropriately. Whe... | |
| Duelund conversion to DIY Helix Geometry Cabling Dual run Helix air speaker cables is friggin awesome WOW! Everything is just more mature and "confident", better in all aspects. I just noticed the beginning of Cæcilie Nordby - Set them free (Dali CD2). I’ve always found the sound to break down a... | |
| Duelund conversion to DIY Helix Geometry Cabling Thanks @williewonka, I hadn’t seen that page before. Excellent tips :-) | |
| Duelund conversion to DIY Helix Geometry Cabling Steve, is there a photo of how you terminate the solution with the tubes? Otherwise I guess it should be simple enough. I guess the length where the heat shrink directly touches the bare wire should be kept pretty short - 1cm? Do you think I can c... | |
| Duelund conversion to DIY Helix Geometry Cabling Thanks Steve! Afraid I can't afford up-occ for the neutral at the moment, so damn many meters required...I use an active crossover so I have separate helix cables for the tweeter and the woofer. Currently the signal wire for both is the Neotech 14... | |
| Duelund conversion to DIY Helix Geometry Cabling Do we know for sure, that the quality of the neutral matters as long as its resistance is lower than the signal wire? In my simple mind it would make sense that the most resistive wire (signal) is the one that colors/determines the sound, and if t... | |
| Duelund conversion to DIY Helix Geometry Cabling Thanks very much Steve! I wonder what you use for spacing now then? Maybe the tubes fill the sleve somewhat out | |
| Duelund conversion to DIY Helix Geometry Cabling @williewonka Sorry as you probably already wrote it, but the thread is getting a bit long ;-) Will the neutral corrode in the teflon tube, I guess it is not air tight? What dimension tube do you use?I finally finished 1 helix speaker cable (using ... | |
| Lyngdorf TDAI 3400 Digital Crossover I've though about that for a long time, and have run with it for a couple of days. Everything sounds amazingly clear bypassing the speakers crossovers. Running opposite, so the "subwoofer out" (analog) ends up feeding the tweeters via a separate i... | |
| Upgrade Krell KSA 250 to what? You could ask KrellFan1 over here what his journey has been. | |
| Lyngdorf TDAI-3400 Here’s a late opinion about how to make tdai-3400 sound its best.I’ve had the tdai-3400 for half a year, and found it to be great. Without roomperfect it is so-so, but with it sounds wonderful. Thats not surprising and has been written several tim... |