spfury1965
Responses from spfury1965
| RCA to XLR interconnect wiring diagram I must have gotten lucky with the preamp/amp combo. The preamp and speakers have been in my system for a while, but the amp is a new addition and I'm just not hearing the distortion. With a transitor amp it should have been wired ground to pin 1 a... | |
| RCA to XLR interconnect wiring diagram Thanks, ran the 4 signal wires to pin 2 and split the 4 ground wires 2 to pin 1 and 2 to pin 3 and I'm up and running with no hum at all. Brian | |
| RTR electrstatic speakers Sean, thank you for all the research work on the RTR e-stat panels. That was the most info Ive seen so far, the verification of 375hz crossover point was an import piece of the puzzle. I had been swapping speakers in and out of my system with kno... | |
| RTR electrstatic speakers Sean, although I remember seeing the Crowns on the sales floor in the late 70's, it seems that they came out in 73 or 74 and were produced for 2 years. Albert Porter could answer that question. As far as cross over points, I plan to cross at about... | |
| RTR electrstatic speakers Hi Sean, The e-stat panels used in the Crown ES 212 are about 5.625" x 5.625". There 12 of these panels (4 wide x 3 high) used with 2 - 10" woofers. Years ago Don at Crown told me that he thought they were crossed at around 350hz and had a sensiti... | |
| RTR electrstatic speakers Sean, thanks for replying and good luck moving. Jes45 you may be right about the early Wilsons, I'll do some checking. Rwd yes if I can sort out some fairly large issues, I'll build a pair of Line Source speakers using the RTR's. If you have quest... |