spaninc
Responses from spaninc
| VPI SDS output voltage I measured the voltage with the table pluged and on. I get 10VAC? seems my SDS is in need of service. | |
| VPI HW19MKIV huming motor I changed the ramp voltage to 115V but when I turn it on I only see 72? is there a way of memorizing the new voltage that I am missing? Must the SDS go straight to the wall outlet? Rique | |
| VPI HW19MKIV huming motor I connected the table to the wall and it works fine. Seems SDS is not putting out enough juice but it working fine. Anybody know what to do with the SDS? | |
| VPI HW19MKIV huming motor I have a PS Audio Power regulator to where the SDS is connected to. Never been a problem. Will check the pulley but don't think its the problem. | |
| HDCD VS SACD I believe that who buys what is not an issue on this thread. The bottom line is as far as audio quality goes:CD HDCD-XRCDSACDSACD sound great no question about it. I usually purchase used ones on the web rangin from 7 to 19 U$.Riqe | |
| Sprung vs Unsprung VPI Turntables. I rest my case. Riqe. | |
| interconnect suggestions Aside from good sound I want a cable that is not prone tointerference from broadcast and others... | |
| Using XLR for Phono out Romaxim, I was planing on connecting RCA to XLR adaptors on the output of the VPI JWM tone arm when I realized theGCPH has only RCA for inputs. However, outputs from this amp are true XLR so I guess that part is solved by default | |
| Using XLR for Phono out The outputs on the JWM tone arm I have are RCA SE as are the inputs on the GCPH, so after the signal is processed by the phono preamp (GCPH) it comes out through the balanced outputs to the amp...balanced I suppose! No other way out unless VPI fig... | |
| Using XLR for Phono out Hi, all I got a response from Cambridge Regarding the XLRs electronic inputs plesae see below."Dear Enrique,Thank you for your email.The XLRs do connect to a balanced input circuit, which gives cancellation to common mode noise picked up on the ba... | |
| Using XLR for Phono out Me again, this is what Cambridge sais: The Azur 840E makes room for eight inputs, including two fully balanced XLR inputs! guess that responds some questions. Enrique | |
| Using XLR for Phono out Thanks everybody, I guess I will have to experiment. By the way I will let you know if the Cambridge 840E is truly all balanced.Enrique |