sf82
Responses from sf82
| euro speakers for Luxman SQ-N150 I had the sq-n100 and really, there is a limit to what those small tube amps can handle. (Didn't handle ProAc D15 at higher volumes) Unless you only listen to mellow acoustic music at low volumes, you should probably look for above 90db and 8 ohm... | |
| Tannoy Stirlings on the way! @trentmemphis Have Cheviots with Luxman 590AX. Lots of power. Smooth, but still a lot of punch when needed. Tons of versatility if that matters. Phono, separate, loudness, tone controls etc. | |
| What’s the Right Power Amp Ratio For Bi-Amping? With speakers that have seperate terminals for LF and HF, doesn't that remove the problem with both amps sharing the same load? Or does it not matter because the amp "sends out" the same signal regardless of what it is connected to? For example, ... | |
| Hacking a Luxman Integrated Thanks a lot. I see all current and last generation Lux power amps are 29dB as well, so it looks like I'll have a go at biamping sometime in the future | |
| Hacking a Luxman Integrated Hi all Have any of you tried to biamp with a Lux integrated and a Lux power amp added via the pre out? Currently own a 590AX, but could be a fun experiment to try biamping with m700 for example. I haven't found any numbers for the gain in th... | |
| Class A into Class AB @deadhead1000 The 590s are also A/AB. Goes up to approx 90W in AB, so there's your headroom.Fantastic amp, I have the AX, but not just class AOn the other hand, this probably shows that it's difficult to notice it moving from A to A/B | |
| Helping a friend build a new system Luxman SQ-N150 (or SQ-N10) are very nice tube amps, with a small footprint. Excellent headphone output and MM-stage. Tone controls for his hearing.Really good with voices etc. Needs a reasonably effective speaker, but has a good power supply. Used... | |
| From Naim to Luxman...? Can't compare, but I have previously tried the SQ-N10 on the Forte III. Auditioned the combo several times, before choosing the Tannoy Cheviot. Also used the SQ-N10 for a while on ProAC D15, before the change mentioned above.The SQ-N150 I've only ... | |
| LUXMAN L509X VS M700/C700U OP - sorry if I misunderstand, but are you saying that your're planning to use 2x mq88? As in mono-blocks? | |
| LUXMAN L509X VS M700/C700U OP - any updates on the 38/700-combo? |