malammik
Responses from malammik
| Recommendation for TT power @Tubehead21 and @Zd542. I think you're both proposing same solution. I will research that and most likely end up going with something along those lines. Thanks a lot folks! | |
| Recommendation for TT power @Viridian, you're 100% correct. However, when I put my hand against the motor, I can feel ever so slight vibration, so it is definitely doing something when it is not spinning the platter - there is no sleep mode in it. I am concerned about long t... | |
| Ever so slight platter wobble It is a crapshoot but not necessarily always on a bad side. I have Antique Sound Labs amps made in China. Build quality and sound quality are very good. | |
| Ever so slight platter wobble Hey. The wobble video is wobbly. The table was on a floor and I did not have good support. Thanks for the advice. I will try that out. The platter is not sandwiched. | |
| Ever so slight platter wobble Here is a video of the wobble http://vimeo.com/8338593 | |
| Ever so slight platter wobble This does not sound idiotic at all. I do not know much about this table so I am not even sure which side is top and which is bottom and I tried it both ways. I will wait to get home tonight and try Bob's suggestion of various positions to see of t... | |
| Ever so slight platter wobble Thanks Bob. I will try that. | |
| Ever so slight platter wobble The bearing itself is mounted straight and secure - I've mounted it myself. Platter is made out of glass acrylic. The distance between the platter hole wall and the outer edge of the bearing is not even. At the bottom it is tight and there is no p... | |
| One channel gets very quiet after bias is adjusted My right channel sounded less lively and tiny bit less lound on a number of records. So I swapped the tubes left and right. It is a 300B SET amplifier and now the left channel had this kind of laziness to it. One of the tubes where laziness is obs... | |
| Ever so slight platter wobble There is play between the bearing and the platter if I press if my fingers very slightly onto the edge. |