leisual
Responses from leisual
| what's causing a SME 3 to stick after a few spins? The only response I got was from SME simply stating that they don't support the series III anymore. No one else responded including a couple of other companies I came across.The only thing I have to add is that while working on the motor of the Re... | |
| what's causing a SME 3 to stick after a few spins? "Luckily" after playing through 3 sides without incident this morning I got stuck in a groove on the first track of the 4th side. I found some thread, looped it around the arm like you said, lifted it up off the lp and tried to move it toward the ... | |
| what's causing a SME 3 to stick after a few spins? The problem occurred when I first hooked up the turntable after arriving from Fed Ex. It eventually improved and then returned after I adjusted the overhang. This mis-tracking went away also and now seems to be working just fine. By skipping I mea... | |
| what's causing a SME 3 to stick after a few spins? That sounds right but when I lower the arm in the space between the arm rest and the platter it drops a few mm below the lp surface. Thanks anyway | |
| Building high-end 'tables cheap at Home Despot II If I've got rust in the motor should I just bail out now? I started cleaning up an L75 I bought through an ebay auction and I wasn't too happy to see rust and corrosion spots underneath. When I opened the motor up there was rust inside and rust wh... |