dolphytrane
Responses from dolphytrane
ZYX Compilance @chaksterThe specs I was referring to were for the Technics EPA-100 it was just a typo.If we take your Reed example with cart + arm = 25.9 (arm18g) with a compliance of 25.5 the Rf would be 6.19.Could you do the equation and tell me if you get the... | |
ZYX Compilance Thanks, quote as stated by GT AudioEQ Compliance horizontal - 15×10-6cm/dyneEQ Compliance vertical - 12×10-6cm/dyneRecommended tonearm effective mass 12grams minimum/20grams maximumWith the TB or SB headshell added it will be:+TB - recommended ton... | |
ZYX Compilance @chakster I do have a Zyx cartridge & in my manual it simply says 'Compliance' it does not state whether it is Dynamic or Static or what it is measured at either 10hz or 100hz, hence the reason for starting this topic.If the compliance is how ... | |
ZYX Compilance I found this on Vinly Engine can anyone confirm Zyx is a Japanese maker and Japanese makers usually specifies their compliance at 100 Hz, so if we say a static compliance of 15 @ 100 Hz, this means a dynamic compliance of roughly 7.5 @ 100 Hz. Now... | |
ZYX Compilance Using the above to calculate compliance to get a resonance frequency of 11 I need the total cart + arm mass to be 8.2g since the cartridge itself weighs 8.6g this is impossible.Next question, what tonearms are being used with Zyx carts with the si... | |
ZYX Compilance Informative article, thanks | |
Difference between Airy 3 silver & copper Very informative, thanks Doug | |
ZYX Airy 3 Best SUT Thanks BnrlawThis sounds perfect. I did not want to mess around with resistor loading.Thanks again for the advice. | |
ZYX Airy 3 Best SUT Sorry folks it was a typo the output is .24mv |