bhenry91
Responses from bhenry91
| VPI TNT 3 Regarding the PLC not working for 45rpms… I took the PLC into my local Audio Repair tech… and in about 10 mins he had it working! He said it just required a small adjustment! And sure enough it spins 45’s right on speed. Fantastic! | |
| VPI TNT 3 Quick question, right at the moment, I’m using my old PLC box (that came with my HW-19) to adjust the speed control to get 33.3RPMs tested with a stroboscope printed disk. To get 33.3 I need to turn the adjustment dial down to about 9:00. However... | |
| VPI TNT 3 Again, thank you for all of your replies, great community for sharing ideas. Appreciated! The platter that I have on my TNT3 is 1.5” thick, with the bottom 1” appears to be aluminum with 7 grooves around its perimeter, the top 1/2” appears to be ... | |
| VPI TNT 3 Well, you certainly raised a good point about the Sorbothane (double sprung isolation), I switched the Sorbothane legs over to standard solid tip-toe mini cones… and I can tell immediately that the bass was deeper (maybe stronger and more focused ... | |
| VPI TNT 3 That is a very good point that I did not think of… I thought I was just being resourceful re-purposing those Sorbothane legs! I will definitely take them out and substitute some old tip-toe cones in place! I will report back if I hear any change... | |
| VPI TNT 3 Again, thank you for all of the great responses! I will look for that FB page! Thank you. Yes, my TNT 3 does have spring coils inside of the corner towers! I have re-purposed a set of Sorbothane legs left over from a HW-19 Jr upgrade to a Mk I... | |
| VPI TNT 3 Thank you for your quick replies! I have reached out to VPI, but they are quite hard to get ahold of, however I did chat with a very friendly lady there who took down my information and was going to get the right person call me back today! I will... |