393gadget
Responses from 393gadget
| Connecting Amp to speakers When you read the specifications for speaker cable, you realise the manufacturer takes a lot of care and attention in its production to iron out any anomaly that may or may not influence the signal quality, then a banana plug is fitted, an inch of... | |
| Bi-amping Cheers, I think I was bogged down by the alternatives, which now, I have realised does not apply or answer my ambiguous question. Thank you all for your replies. | |
| Bi-amping My speakers have built in x-overs, so does that rule out the use of electronic x-overs, as I said, maybe this forum is for the tech savvy’s only, I just want to be able to have my system enabled to produce its best performance. | |
| Bi-amping Sounds very technical, to an amateur, my speakers each have four terminals, so the amp will be connected to one set of the terminals, is it as simple as that no setting up need? | |
| Bi-amping Thanks for the comments, I’ll be shopping for additional speaker cable, and certainly give it a try, all I have to do is obtain advice from my local retailer on the steps forward. | |
| Arcam 850 fault code Appreciate your reply, I shall be sending the amp for repair, just wondered if anyone out there have had the same fault and the outcome. |