Lightspeed Attenuator - Best Preamp Ever?


The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
pubul57
That is interesting George. Why do you think the LSA is immune to a battery supply?
Because all the supply has to do be it battery or mains, is to hold the LED Light (light emitting diode)steady at a predetermined (by you) luminosity level between 1 and 20mA, this LED in turn shines on the LDR (light dependant resistor)which changes the level of resistance needed to change the volume of the source to the poweramp. As you can now see the power supply has no electrical contact with the LDR or signal. And the led is gas (no filament) so it is impervious to vibrations or shocks.

Cheers George
I have the battery supply as well. It changes the sound, slower, more polite IMHO. I will listen to it again.
Given George's comment, it would seem the burden of proof is on explaining a difference, not the other way around. I find Clio9's comment interesting, as he does hear a difference, but even there hard to put your finger on it, also hard to measure the influence of expectation on something so subtle. However it may be, going to battery supply just doesn't seem like a path with pursuing, at least not to me.