Hales Design Group Speakers...Removing the Grills

Have you actually removed the grills on HDG speakers? They do not simply slide up and off either vertically, or laying on their backs on the ground. The grill is actually just a sock over a metal frame which is attached to the speaker body.

It depends on the speaker. I own Hales T-8s and Hales Cinema Centers. On these speakers, Audioparts Inc. accurately described the process. Just grab the grills from the bottom and slide them upwards. For the T-8s, of course, make sure you have sufficient ceiling space (approx. 8.5 feet).

The speakers have something like a big rubber band all around the metal frame to secure the grill cloth. You basically grab it by a corner and pull it out carefully. They are a pain in the *%@! to put them back, and have them look good. It can be done but this is not something I would want to do frequently.

I suspect you have Hales Design Group "Revelation" speakers. The Concept line and the Transcendence line have metal framed grills that slide up and off the speaker baffle. The Revelations have a "sock" that fits in a groove where the baffle meets the speaker body. I have known of these being removed but very difficult to reinstall. If you have the February 1998 Stereophile there is an article about the Revelation 3's and a small blurb about the grill cloth (pg 118). In short it says what I said above "While it's possible to remove the grillecloths, doing so without damaging the fabric is a tricky matter, and replacing them even more so."

If you have ever seen carpet being installed I.E. where the carpet is tucked between the tack strip and the base board with a wide flat metal tool and a hammer you can get an idea of how the cloth would go back on. I mention the carpet only as an analogy. DO NOT use the wide metal tool used for carpet installation and a hammer less you chip the baffle to hell. You could possibly try using a tool used for installing screen in a window or door frame. It is basically a handle with a roller on one end and can be had at any hardware store.

I owned HDG Concept 3's and currently own Transcendence 5's and I can say without question that I prefer the sound with the grills OFF. Hope this helps.

Well, I am going in for a few reasons, namely:
1. Used to live with a smoker, and they are probably filthy
2. To dampen the frame with some rubber wedges, as some have suggested
3. To check the tightness of the driver screws and bolts, as suggested.

I may do it tonight...I've got my whole theater torn apart anyway as my pass is in for service.