2. amps-preamps
  3. 182426-123790

Budget amp that will give Magnepan 3.6Rs better depth of soundstage

I have 3.6Rs and using Emotiva UMC200 pre/proc and an Outlaw Audio 7100 in a 14 by 14 foot room. So I don't need to turn the volume up to massive levels. The amp will do 100 watts per channel into 8 ohms and 165 watts per channel into 4 ohms. I have been thinking of getting a separate two channel amp for the 3.6Rs. I have read that it takes lots of current to get the best soundstage with instrument placement and depth. I am getting wide soundstage and good sound, but the depth is somewhat muddied enough to not get instrument placement. I am looking for a two channel amp that will give me more of the potential of the 3.6Rs, but be able to be purchased for less that $750 used.  Is there any amp that will be worth upgrading to for that kind of money or do I need a new pre/proc as well?

cdavis2260
riccitone
219 posts
 

The room would need addressing before considering more power, but a better amp can make some significant improvements to the presence, dynamics and stage. 
 

What about wood diffusion behind the speakers along the front wall and then on the first reflection points? I purchased some cheap and very effective BXI quadratic panels on Amazon that did amazing things for the imaging and stage depth. 
 

 

Ag insider logo xs@2x
bouncehit
73 posts
 

I’ve owned numerous Magnepan models spanning 40 years time, and currently use MG 20.7’s.

 

in this order:

6’ from rear wall (put them on casters with locking wheels if need be)

experiment with toe in-mms matter

cheap but great amps? Crown Pro series, carver sunfire, parasouund. Adcom

 

good listening!!!

ross6860's avatar
ross6860
103 posts
 

I am currently running Magnepan 1.7i in an 11' x 14' room with two REL subs.

Speakers need to be 4'-5' from the front wall.  

I have used as little as 25 watts to 50 watts from a good tube amp.  Only bass was improved with big SS power.

For $750 or less, you are looking at older amps.  I had an ATI 1502 (225 watts @ 4 ohms) that did fine.  Look for high-current more than just a watt rating.  

Unfortunately, a lot of these older amps are due for service.  

 

 

 

 

 

 

mbmi's avatar
mbmi
455 posts
 

Peachtree GaN 400 watts @ $ 2500 run my Maggies Beautifully.

bikefi10
35 posts
 

I agree with those who suggest room treatments 1st.

If you want to try an amp less than $750 that can definately drive them, Ive got a recapped Carver M400 I would  part with. 200wpc 8ohms, over 300wpc 4ohms. It drove my 1.7i s at high spl for hours without getting warm. 

My new $2k + amp sounds only a little better in detail, but same as far as soundstage.

More to discover