new GAN amplifier


LSA Voyager GAN 200.

https://www.underwoodhifi.com/products/lsa-electronics

200w into 8 ohms

400w into 4 ohms

???w into 2 ohms

128x128twoleftears
in the case of the Alexia where one just has to look at the frequency response/impedance curve to see it, often correct peaks (valleys) in the frequency response. It is like a built in equalizer :-)

You are both "Dreamer’s", the OTL’s are NOT fixing/correcting anything, as there’s nothing to fix on the Alexia’s.
They can’t drive those Alexia loads, because of "lousy damping factor" and "minuscule current delivery" (and are a tone control because of it) not "equalizing" as you say, read carefully, Stereophile say it twice.
Stereophile on Alexia:
" The peak in the midbass is entirely due to the nearfield measurement technique."
" The broad peak in the midbass will be mostly due to the nearfield measurement technique"

The more you both try to dig your way out of this nonsense, the more ridiculous you look. With your comments made about OTL’s and them trying to drive speakers like these Wilson Alexia’s ect ect that have horror loads.

Next I’ll put money on is you’ll drag out the (autoformer band-aid fix) solution.
Post removed 
Please compare data for your favorite top A/B amp U-LD Mk4, given by the creators at www.siliconchip.com.au (August 2015) and the newest D-class from Bruno Putzeys - Purifi 1ET400A (www.purifi-audio.com).

Best to use third party measurements such as these... https://www.audiosciencereview.com/forum/index.php?threads/review-and-measurements-of-purifi-1et400a-amplifier.7984/page-1

Distortion (IMD) is still higher than a decent classic blameless AB design above 10kHz.

The Hypex modules I'm using sound pretty good as full range amplifiers, but with the AB driving mids / tweeters the fidelity goes to another level.  

As Putzeys himself has stated, Class D amplifiers sound good in spite of being class D, not because of it. 

A lower damping factor will, and especially in the case of the Alexia where one just has to look at the frequency response/impedance curve to see it, often correct peaks (valleys) in the frequency response. It is like a built in equalizer :-)

And .... most people don't know this, so I will not fault you, but high damping factor often results in more distortion in dynamic drivers. So no, high damping factor is not always better. Different yes, but better ... not necessarily so.

 A poor damping factor will raise the designed loudspeaker system Q to beyond the point of optimum damping, and because low frequency impedance is typically modulated by the signal itself distortion will always be lowest when driven by an ideal voltage source. Noting too, if damping factor is close to "1" by definition half the power is also being dissipated in the source impedance. That's definitely not desirable. 

Not surprisingly perhaps, 99.9% of high-end commercial speakers are not particularly amplifier friendly and are clearly designed to be driven from a very low impedance source (ie. ideal voltage source). 


arty_vandelay
You wrote:
"Distortion (IMD) is still higher than a decent classic blameless AB design above 10kHz."
Do you mean this part of Amirm's test:
"I was surprised to see the rise in distortion with frequency. I had hoped that the super high gain-bandwidth of the 1ET400A would do away with this. Not an audible concern though as the distortion products here are all in ultrasonic range. [...]The Benchmark AHB2 does a lot better since it has much cleaner ultrasonic spectrum.".
Well, ASR is known for measuring audio phenomena that no human can hear. A concern for bats, perhaps. As for the 18khz+19kHz IMD, Purifi is absolutely tops, not to say that no other manufacturer provides those data. Amirm writes:
"Bruno had encouraged me to run intermodulation test with 19 and 20 kHz tones. I matched levels with Benchmark AHB2. I was surprised to see so much lower intermodulation distortion with 1ET400A. The first pair of sidebands is more than 10 dB cleaner and the rest almost don’t exist!".
The Benchmark AHB2 is Amirm’s/ASR reference A/B amp. "The cleanest amp on the planet".
As for subjective perceptions of audio, to paraphrase the local classic, "there are many, me including, who like tubes best".