2. analog
  3. 129208-24605

Classic 3 VPI

My Classic 3"s belt squeals upon turn on.  After a couple of seconds, the squealing stops.  I've tightened the pulley, installed a new belt and did what VPI recommended, I powdered the belt.  After applying powder, the squeal quietened but squealed again on the very next try.  I reapplied powder and the same thing happened.  Any advice is welcomed.
donpenland
gshepardbuster's avatar
gshepardbuster
620 posts
 
+1 for spinning by hand!  
lenmc2964's avatar
lenmc2964
239 posts
 
My Rega RP 3 just started doing the same thing. My white belt has around 120 hours of play time how long will a belt last? Also can I use two belts on the RP 3? 
jjss49's avatar
Ag insider logo xs@2x
jjss49
6,612 posts
 
two belts sure helps, as mentioned above


jjss49's avatar
Ag insider logo xs@2x
jjss49
6,612 posts
 
lenmc - u need to check ur rega table pulley - does it have grooves for more than one belt?

on the vpi classic 3 the pulleys have grooves for 3 belts
brf
1,715 posts
 
If you are planning on using more than 1 belt on your Classic turntable, make sure that you have the correct non-stepped pulley often referred to as a HRX pulley. 
More to discover