Emotiva XSP-1 vs XSP-1 Gen 2


Compared to our modified Audio Research LS2B MKll, we tried the 1st iteration of the Emotiva XSP-1. Per "The Jazzmama" It was depth-less, flat, 2 dimensional and "uninvolving."

In comparison, how does the XSP-1 Gen 2 perform with respect to the depth, holographics, 3 dimensionality, and staging as compared to the Original.

The ERC-3 is incredible at any price. The XPR-1 monoblocks are Kilo-buck monster eliminators.
levchappy
George,

Thank you for the feedback.

I'm familiar with Bryston amplifiers. What model did you have?

Can you tell us anything else about your system?

Thanks again for sharing your experiences, TJF
I have the XPR2 amps run in a passive vertically bi amped set up .My speakers are 90 db but Need a lot of power to really drive 4 9 inch bass divers per side . I have tried with smaller amps . These move air and in turn move me .
600 wpc at 8 ohms and 1000 wpc at 4 0hms . my speaker are 8 ohm

I have 3 dedicated 20 amp lines in my room and would recommend the same if you a going to drive them hard or your speakers are 4 ohm or less .

I will definitely recommend The XPR2 amps and would imagine the XPR1 to be as impressive if not more .

The only comparison I have is a friends system with Classe omega monoblocks at 600 wpc if memory serves me correct . It was impressive but also 90,000 dollars more than my system .
Runnin;

Do you know the difference between loud and detail, staging, depth, 3D holographics, deep base detail, high hats shimmering? More power allows more headroom, and greater control over the speakers. I use a decibel meter and keep the sound level at no more than 84 dB.

Perhaps you might consider making your first Audiogon purchase and test this out?
99.9% of audiophiles do not need 500 or 600 watts to do the above, Lev, with a decent well put together system. Some guys achieve the 3D staging, detail, etc., with a small tube amp and efficient speakers. The audio world has been able to achieve excellent audio previous to the XPR amps being released, so suddenly it never happened and we must sell our amps and all buy the XPR series? I remain a sceptic.

Emotiva has as much as admitted you will never use all 600 watts when they themselves said you don't need a 20 amp circuit, which means you won't be using 16-20 amps or all of the power anyway. I think it's mostly the braggers or headbangers who will buy these silly amps of 600+ wpc and give themselves hearing damage.
Tjassoc
Please check your messages.
I just send more information regarding my impressions of XPR-2,and comparison to Bryston amp.
Thanks
George