Tone controls to get bass from small speakers?

This is easy. Just chase a used NAD 7100, 7400 or 7600 receiver.
They had a Bass EQ switch that pumped up the bass from 35-80 Hz or so, with a steep drop below 30Hz. This is pretty effective with WELL-DESIGNED 5 or 6 1/2" two-ways that don't have noisy ports (that as well are tuned below 60Hz or so). Gives good extension WITHOUT the excess warmth of a regular tone control. You have to start with a decent speaker, though. The other nice thing is that you could leave this EQ in and still bypass the other controls for a cleaner signal. Yet the preamp as a whole was the weakness of these receivers...the FM tuners the highlight. Still using my 7400 in the HT/second system.

Simple, you want enhanced bottom end, well, start at the source, your cd player can push out lots of bottom end and then there are cd players that are bass shy, same with needles and tonearms. find a source that hits the bottom end hard. The new music fidelity dac which is coming out in may I think, I have the prototype, you'll be amazed on the bass that comes out!!!! find a neutral transport for it, it can be a cheap pioneer or an expensive wadia, listen to this dac, and you'll hear it. Oh, and good solid state amp would help just as much, like Bryston amplifier for example, I don't think you'll need anymore bass than when you listen to one of their amps, especially the new 14B, ha. your cables help, speaker cable, experiment, this way all your bass is natural and in full detail, and trust me, with this combination, you'll have all the bass you can handle or want. I have bookshelf speakers that produce more bottom end, not to mention better bottom end than many floor standing speakers. The stands helped incredibly, my stands are so heavy being filled that it takes two guys to carry one speaker stand.

Guys,
Again, thanks for your insights. I'm doing a lot of web surfing with all this great information!
Steve

Before you spend big bucks try putting some vibrapods between Spicas and stands, you will be amazed at the increase in bass response.

If you try this with larger floor standing speakers it will often produce too much bass, but small two way monitors respond very well to vibrapod decoupling from stand.

I've had my 3030 in for upgrades, one being tube sockets, which allow me to change tubes. However, the bass on this integrated amp is solid state. I think this amp will show more with a better source and cables. I run a Rotel 955AX with a set of solid copper Lindsey Guyer intercoonects, which gives a hint of bass through my 1Bs. I'd hook up an analog source and see if the bass response is better. This amp needs a well matched source to show its best.