dip them in cleaning acid. You can get it at hardware store. Be careful of course.... Dip pin only in a small glass container / small glass bowl or pyrex (only about 1/8 to 1/4 depth of acid) for about 30 seconds and then neutralize in baking soda solution (water and baking soda in another glass bowl for minute or so. Wash tube with joy and water if possible. Will remove any chemicals bonded when tube was made. no need to sand and works better. Acid is cheap, couple bucks for small amount. obviously only small pin tubes - works great on NOS nine pinners.
- ...
- 19 posts total
I use a tool called Fyberglas Rush eraser. Its bristles extend and retract with the twist of the cap, almost like a tube of Chap Stick. The fine fiberglass bristles are self replenishing in that they wear away as they clean. Polishing tube pins with this tool works as well as the Dremel and avoids the steel wool and corrosive acid problem, requires no electricity or special skill and is inexpensive. http://www.eraser.com/browsecat.cgi?mode=open&id=113 I told Michael Percy about this 10 years ago. I think he sells them now If you don't want to deal with The Eraser Company. |
After discovering the merits of using a "MAJIC ERASER" product for cleaning styluses, I thought I would try using a piece of this material to carefully clean tube pins. Does an excellent job with no residual debris. Then I treat the sockets and pins with KONTAK, using a fine syringe for the sockets and lint free applicators for the tube pins. On the whole, this is reasonably quick and works well. I notice much cleaner high frequency reproduction. It's worth the effort. Just be careful when treating sockets to let the pin interface dry after re-inserting the tube in it's socket. This is also an excellent process for cleaning and treating bare copper spades and binding posts. Yields a similar audible improvement. |
- 19 posts total