What does more power do for Magnepans?

For an understanding of audio output in db, and power requirement, read this:(http://www.axiomaudio.com/power.html) It would be nice if doubling the perceived sound only required doubling the power. The least I've powered Maggies with was a slightly modded Dynaco ST-70(about 17W a side in reality). Yes- They sounded nice, but realism could only be approached listening to small acoustic sets. Remember that you're driving a nominal 4ohms too, and look at your amp's output into that load before you shop for power. I'm trying to think of ANY live music I've heard in the last 48yrs that was, "lush, thick and gooey." Was it the 'Hot Fudge Sundaes'? NO-that was at Baskin-Robbins. Hmmm, let's see.......

hi narrod:

thick and gooey means severely attenuated treble and highly palpable midrange.

It's not about loudness, it's about controlling the panels. Tubes have a more difficult time doing this. Therefore, more tubes in parallel whether it's push/pull or single ended, lowers the output impedance,(plus or minus an output transformer). Dampening factor doesn't seem to quite explain it either. It's got to do with realism... With tubes, you'll simply need a ton of watts.
As you add devices to gain power, you lose delicacy, kind of a trade off.

With 3.5's I vastly preferred 200 wpc over 100 wpc when using solid state. Same series of amps, both new, just the power difference. I also performed this test with 2 different brands of amps with the same result.

The 1.6's are far easier to drive than 3's or 20's. yes, I've heard 3.5's with 35 watts, I've heard them with 4 watts, while the 35 watts was almost acceptable, it just didn't do it for me. My room is rather large for panels
though, so your results may vary.

Try your 3.5's with a borrowed 50 watt amp, see if you like it. That may help give you more perspective.

Good luck.

not so much higher decibel levels. But more power will protect the speaker form being driven to hard with a lower power amp.

how is a speaker driven to hard with a 30 watt power amp at 72 db, if for example it is rated at 85 db/1 watt/1 meter ?
i would understand trying to produce 85 + db, subject to room size as perhaps being a problem, but not 72db.