2. misc-audio
  3. 994209925

Upper Midrange Glare problem

I am seeking advice to eliminate hard upper midrange glare. I spent alot of money and the sound improved, but the glare is still present. Is there something wrong with my set up, or etc? My systems is as follows:

Counterpoint DA 11.5 transport with Shunyata King Cobra.
Sonic Frontiers SFD 2 MK II DAC with Shunyata Black Mamba.
Sonic Frontiers SFL 1 Signature Pre Amp with Shunyata Viper.
All above components connected to the PS Audio P300 with a Shunyata King Cobra attached to it.

Bryston 7B ST Mono block with PS Audio Lab Cables connected to two Ultimate outlets which is connected to XLO Type 10 powercords to the wall outlet.

Speakers PSB Stratus Gold, placed 3 ft away from rear wall 2 1/2 ft from side wall, room is 15'wide 21'deep
8 1/2tall. Listening distance is 9 ft away from speakers.

Cables:
Digital - Illuminati D60 - BNC and Illuminati DX-50 - XLR
Interconnects - AudioQuest Diamond X2 - RCA
Speaker Cables - AudioQuest Dragon to highs and Clear 3 to bass.
All Cables are raised by ceramic tiles.

Brights star foundation platforms, tip toes, for each component sitting on a Stand design rack, set of room tunes corners, side walls and tune stripes.

New additions will be XLO limited edition XLR digital cable and Siemens CCa tubes for SFD 2 MK II. Will be here shortly.

Very fraustrated. Any suggestions will be openly noted, thanks.

bowlerds
aragain
39 posts
 
Paging Bowlerds!

Has any of the info posted here helped in any way?

It adds to the knowledge of everyone when we find out what was sucessfull in curing your problem.

Let us know what's going on!
aragain
39 posts
 
To Sean:

On the systems which were cured with your cables, what do you hypothesize the root cause was and how did the cables cause the sound to improve?

Also, what is the effect of placing these cables in a system which sounds good to begin with?

Thanks.
bowlerds OP
5 posts
 
Thank you for your suggestions. I have read all the feed back and noted all of them. I made some changes to the room and the settings on the PowerPlant. My system sounds impressive. Something to enjoy and be proud of. I am also going to upgrade my preamp to a Herron VTSP 1A or the Levinson 380S.
bowlerds OP
5 posts
 
I found out my front end responds better to the PS2, SS5, SS6 settings. I made minor toe adjustment to the speakers . I found that the cables were not the problem even tough I ordered the XLO limited digital, I guess it would be better than what I have now. My Siemens tube are due to arrive today. I will replace them on the DAC, it should sound better than the stock Sovtek 6922.
sean
6,231 posts
 
Aragain, i have NO idea as to what causes some interconnects to be audibly different than others or work / not work within specific systems. All i can say is that i have experienced such things first hand and i'm sure that many others here share that experience and point of view.

As to using these cables in a system that already sounds good, that is WAY too much of a variable to make any kind of educated guess at. If the cables that were originally in the system had similar electrical characteristics to the "gas busters", i would assume that the audible differences would not be very drastic. On the other hand, i have heard these cables sound FAR WORSE than the generic factory supplied OEM interconnects that are supplied free of charge with a lot of gear. As i and many others have mentioned here before, it's all strictly trial and error. Sean
>
More to discover