Subwoofer Speake Cable - Important??


So, I'm using an old pair of Linn K-20 speaker cables to drive my sub. They're just a pair of multistrand copper cables. I figured no point spending good money on speaker cables just for my sub right? Mind you, I do believe in the value of good cabling for full range speakers. Is my logic sound?
pawlowski6132
I think your logic is perfectly sound. You might test it by borrowing a
"better" cable, but if you're really objective about the comparison (or
have someone switch cables without telling you which is which), I'll bet you can't
tell any difference. Other cables, definitely yes. Sub cables, no, especially if
your sub does its work below about 50 Hz. Good luck, Dave
Of course you should pay attention to an appropriate bass power amp at first place. The Crown K2 is top class for bass and at a moderate price point.

The speaker cable for subwoofer makes quite a difference. I have – well had, as I’m just in the process to switch to a Maxx2 - the Wilson Audio WHOW subwoofer with the crossover point set to low 52 Hz, so you may think this is a small bandwidth and the cable may not be important.
I tried several cables – 3-4 ft. mono runs, starting from a 10$ standard cable, to a 100 $ XLO reference 6A cable, to several 1000+$ cables. I ended with the fantastic Elrod speaker cable, which is not only superior as a bass cable but also as speaker cable for my Watt/Puppy (where it replaced the twice as expensive Nordost Valhalla).
1100 $ retail price is high for a 3 ft. mono run, but matched with a first class sub like the WHOW, it’s worth the investment.

Bass gets more power and control, it sounds as it goes deeper with the Elrod.
I too have a Stentor and would like to replace the supplied Neutrik Speakon High Level cable. "The Cable Co", was not able to locate this particular cable, and both emails to XLO weren't answered. Any suggestions?