Review: NAD C-320BEE Amplifier


Category: Amplifiers

The NAD 320BEE is used as the power source in my second system. It is a 2 channel system that is used for both music reproduction and home theater. The NAD 320BEE replaces a Harmon Kardon 3370 receiver (used as a preamp) and an Audiosource Amp 2 power amplifier. Replacement was necessary as the HK 3370 shorted out and went up in smoke. Previous to this set-up, a Denon 2801 home theater receiver was used. The NAD 320BEE was purchased at Harvey Electronics (NYC).

Music/Sound Reproduction:

Both male and female vocals were clear, deep, full, and warm sounding (Nanci Griffith, "Winter Marquee"; Raul Malo "Super Colossal, Smash Hits of the Mavericks"; Frank Sinatra, "Songs for Swinging Lovers"). Guitars and strings, in general, were crisp, distinct, and revealing (I heard guitar lines in Neil Diamond's "Shilo" for the first time in 30 years). Rock music sounded exciting and powerful (Rolling Stones remastered, "Let It Bleed"); compelling and inviting (Robert Plant, "Dreamland'); and alive, with well reproduced bass (Doves, "The Last Broadcast" and Metallica, "S&M"). Horns were clear and deep and had just the right edge to them (Clifford Brown, "With Strings"). On action/adventure DVD's (James Bond, "Tomorrow Never Dies"), explosions/gun-shots/crashes/helicopter roars were loud and in-the-room realistic sounding.

The NAD 320BEE plays loud. The NAD replaced previous units that were rated as having more power, but the NAD just sounds as if it has much more power. It drives my AR speakers (85 db sensitivity) with ease. In fact, the NAD really brings out the best in the AR's (very musical sounding, full range speakers capable of going down to 35 hz).

Product Features and Build

The unit appears to be solidly built and has good heft to it (it weighs in at just over 14 pounds). It has inputs for 7 sources (cd; video; disc; tuner; aux; tape1; tape2 ), as well as defeatable tone controls and NAD soft clipping. The unit is supplied with a remote control that can be used with other NAD products (CDP; tuner; etc). My only two quibbles with the general design (and they are minor) are: I would have preferred a "lighted" volume control (so, I can see the volume level in low light conditions) and a detachable power cord.

This is my first piece of NAD gear in 31 years of enjoying quality gear (I got started early ... when I was 14). I enjoy believing that if I pick quality equipment up front, I can spend my time listening to the music and not worry (so much, anyways) about the gear. So, my comments are usually about how the music sounds and not so much about soundstaging; etc. (if you have house cats, speakers are usually placed where the claws aren't). The NAD320BEE is a quality piece of equipment that makes the music sound very good.

Product Weakness: Not forgiving of poorly recorded music sources.
Product Strengths: Smooth non-fatiguing sound. Excels at music reproduction (vocals; strings; brass). Quality product build and full feature set.

Associated gear
Pioneer Elite PD-65 CD Player; SONY S560D DVD Player; Acoustic Research 302 Speakers Classic Series (85db sensitivity); IXOS GAMMA SILVER 1002 interconnects; Radio Shack Gold Series 16 gauge speaker cable
128x128rar1
Van:

My hunch is that your bass definition issues may lie with the Ruark Epilogue speakers. These speakers are mini monitors, designed to work in small rooms, that only go down to 55 hz and need to be out in the room to be able to go that far down. The usual questions come up here now ... what is speaker placement like; what type of speaker stands are you using; how big a room are you using the speakers in; etc. The NAD C320BEE can be paired with a wide variety of speakers ... I was using AR 302's which can go down to 35 hz and the bass was tuneful and crisp.

Regards, Rich
hi Rarl,

Many thanks for the prompt reply. My room is 5meters by 3 meters. I've placed my setup along breadthwise .25m from the wall and I'm seated 2.5m from speakers. Actually these are the best I could do. My speaker stands are non-branded but steady (with spikes). Tried bringing the speakers closer to the wall but it gets worse.

Have you heard Spendor S3 with NAD?
Hi Van:

Does moving the speakers out into the room (a meter or so from the wall) improve things any? The Ruarks are designed to operate ideally out in the room. The bass may be sounding smeared because the speakers are too close to the wall. Alternatively, you could try plugging the rear ports to see if that tightens the bass any.

If you go to Ruark's web-site , under the q&a section, the first item is about speaker placement. Some general guidelines are given and the point is made to avoid placing the speakers too close to rear & side walls. This may be hard to achieve given how you have your room set-up. Ruark goes so far as to say to avoid rear ported speakers, if you will be placing them too close to the walls.

Your listening room is about the same size as where I have my 2 channel HT system. I have my speakers set-up inside of bookcases on the long wall and accordingly, I can only use sealed box or front ported speakers. Most rear ported speakers would be a disaster in this set-up.

I would try different speaker positions, before I invest in a sub-woofer.

Regards, Rich
Hi Rarl,

Did try that but although it gave me improved depth but didn't help me. But you're right in that the problem lies in my speakers. I borrowed a EPOS EL3 from a friend and the bass seems fine (in fact, a lot better)but unfortunately the treble is shiny. Considering that my friend is not keen on music he may be OK to swap :-)

Have you tried Kimber Hero or Atlas Questor interconnects with NAD? I'm looking for a interconnect(since I'm living with a borrowed interconnect at the moment) which is warmer and that can give tight bass and solve the treble issue. How's IXOS GAMMA SILVER 1002 ?