2. speakers
  3. 1266964239

Refurbishing a pair of KLH model six speakers

I just picked up a pair of KLH model six speakers. Hooked them up and the woofers seem fine but both tweeters dead in the water. Found manual on the web but only had four pages. Question is do I want to spend a lot of $ fixing tweeters? ans. no. I understand that the caps go bad and that might be the problem. If so, where do I get the right caps and how do I get to the crossover to replace them? Only reason I'm asking these questions is that these speakers bring back memories.
fhamel
fhamel OP
2 posts
 
Both tweeters are working when hooked to external source. I need two crossovers in working order. does anybody have an idea where I can score them. Tried e-bay, no go.
trigoon
3 posts
 
Hi Guys,

I have a pair of Sixes I bought back in the early 70's from Tech HiFi a popular auidio boutique that started in Canbridge, Mass. Originally at MIT.

I replaced both my tweets as the originals were prone to failure when played at high volumes. I replace the tweets with high end Titanium domes and while at it I redesigned the cross over to cross at a slightly lower frequency to take full advantage of the sweet sounding domes in the midrange. I kept the original woofers.

I replaced the cap with Music caps and the coil too with an oxygen free Cu wire. I used silver solder, no wire nuts, and eliminated the resistors and switch, I replaced the thumb screws with Gold Bananas. Less is more.

Hey its 50 year old technology...the Sixes sound sweet especially on tube equipment which they were designed for. Legendary Kloss.
frank330
1 posts
 
My KLH 6's have sealed cabinets. The woofer frame is sandwiched between 2 sheets of plywood. They can not be removed as they are an integral part of the cabinet. The tweeter is sandwiched in also. The surounds are fabric. All drivers are good. The cloth fabric front is sealed into the cabinet.

I have one pair that is in mint condition and another that I have cut the cloth from to see how they were made. The only way to get the crossover is cutting the back open.

Has anyone else experienced this early 1959 version. I bought mine at Layfett electronics on Route 9 in Framingham mass.
More to discover