Pre-Power or Int Amp for Totem Wind

I was able to listen to a pair of Wind Designs powered by a Halo A21, very very nice.

I owned the Winds several years ago. Ran them with a Krell 400CX/KCT combo...they sucked up every ounce of juice it could deliver (800w/4ohms). Feed them lot's of good power or don't bother getting them. The Totem integrated was notorious for breaking down when pushed on the Winds, ok for average listening levels but don't turn it up too much or kaboom! 200w/8ohms or 400/4ohms minimum with very high current should be the starting point.

I was thinking about putting this system together.
Totem Wind design, Bryston 7bsst, and Wadia 381i. no preamp.
Not much mention of Bryston and Totem ? synergy or not?
I have heard all of these product lines, just not in the same system. anyone out there with a simular set up?
Thanks -

i have presently the new bryston 4b sst square matched up with the bryston bp 26 incorperated with dac to power my winds. Very clean sound with plenty of punch. A whole lot better then Krell.

Maverick...did you remove the glass table in front of your listening position?