Phono Stage with Two Line-outs


I recently purchased a Wyred 4 Sound STP-SE, which is a very nice preamp. I did, however, neglect to notice that it does not have a line-out for recording. I am currently running my turntable through a full-function preamp w/phono, and hooking one tape-out to the W4S and the other to a Tascam CD recorder.

Are there any phono stages in the ~$1000 or less ballpark, new or used, that have two simultaneously active outputs? Are there any other remedies to my situation that I am overlooking?   
minkwelder
Interesting suggestion by LP2CD, which does indeed look promising.  The one question I would have, which would not be a show-stopper regardless of the answer, is if the XLR and RCA outputs are driven from separate output stages.  That is not stated anywhere in the manual or at the website, and in many cases components providing both kinds of outputs simply wire the signal pin on the RCA connector directly to one of the two signal pins on the XLR connector.

That wouldn’t be a major issue in this case, assuming the unit’s unspecified output impedance is not unusually high, but it would be nice to know if the two sets of connectors are separately driven.  If not, the consequence would be that the balanced connection would be slightly unbalanced, as a result of the differing loads on its two signals.  Which in turn would to some degree reduce the noise rejection and perhaps other advantages the balanced connection would otherwise be able to provide.  That would be especially true if the balanced connection were used for the main signal path and the RCA connection for the recorder, given the recorder’s low 10K input impedance (the W4S preamp has a 60K input impedance).

But regardless of that answer, as I said the MX-VYNL looks like a very promising candidate.

Regards,
--Al
 
The user's manual for the M1-ViNL is silent concerning simultaneous use of both the balanced and unbalanced outputs. There is no switching provision. But one reviewer noted this: "There are both single-ended and balanced outputs, the latter generated with a phase splitter -- this is not a balanced circuit." I've only ever used the balanced out, and in fact I have no easy way to test the unbalanced in simultaneous usage. But I would, ahem, assume they are both active at the same time. That said, the fact that the balanced out is "synthesized" and split from the unbalance might make me a bit wary.

While I have no reason whatsoever to complain about its performance, that ersatz balanced out is one reason why I'm considering the MX-VINL myself, as it is supposedly fully balanced. What's more, unlike the M1-ViNL, the MX-VINL uses an external power supply (a "wall-wart" no doubt...) that produces an input of 500mA @ 12V. That would seem to make it very easy and cheap to substitute an 8 C-cell series battery pack for the power supply.
The quasi-balanced and unbalanced outputs of the M1 VINL are concurrently active.  They sound exactly the same and the output levels are identical, too.  I suppose if one were archiving their vinyl and listening at the same time this would be a handy feature, as is the ability to connect two turntables--as long as one is using a MM and the other a MC cartridge. 
*UPDATE*

Success! I pulled the trigger on a used Heed Quasar and hooked it up this morning. It works great with my W4S, as well as the Tascam, and sounds VERY nice; better than the phono stage in my Van Alstine Transcendence Seven I was using.

Thanks, Al, for your in-depth analysis of the Quasar's potential compatibility. It was what I needed to make the decision, and a good decision it was.

Thanks all!
Great!  Glad it worked out, and thanks for letting us know.

Best regards,
-- Al