New Rega RP6

AFAIK, The TTPSU is the same as before other than a spiffier case. For right now the RP6 replaces the P5 only, the 7 will not be dropped from the line until the replacement for that model comes out. So the 6 is not a replacement for both the 5 and 7. The RP6 does not use the RB700 arm, Rega claims the RB 303 is a better arm than the RB700. Rega had to redesign because the tooling equipment for the old RB300 type casting was worn out, the RB303 uses new tooling. The subplatter is the plastic/"phenolic" Rega has always used on the lower P series tables, with an aluminum top piece. The platter is still glass but a lttle heavier and thicker with better inertia. The "brace" between the arm and center hub is metal instead of the "phenolic" on the RP3. The plinth is gloss finish. The feet are same as on the 7 or 9. which I am pretty sure are the same rubber thingies upside down with aluminum casing.

So, any Rega RP6 owners out there????

yep. bought mine in 2014 and the arm is having to be rewired as it crackles when i lift it vertically. upgraded the counterweight as well as the subplatter. i just missed the end of the warranty by about six months... :(

The 6', plinth, has a hi-tech foam core which IMO, should be a departure from previous TTs.

@slaw...the new Planar 6 has the foam core plinth.  This thread is pretty old and talks about the older RP6.  Different tables.

The new Planar 6 is sweet!  I've setup a couple of them.