How to wire audionics cc-2 in mono mode

I couldn’t find a manual online. But after looking at some rear panel photos and based on how bridgeable stereo amps are usually designed I would expect that you should connect speaker + (probably red) to the red output terminal of channel A on the amp, and speaker - (probably black) to the red output terminal of channel B on the amp. The input to the amp would be connected to the RCA connector for channel A.

Also, of course, you would set the stereo/bridged mono switch on the rear panel to bridged mono. And note that the amp is not intended to be used in bridged mono mode with speakers having impedances of less than 8 ohms.

Regards,
-- Al

I owned a pair of Audionics CC-2's.........about 32 years ago! And they weren't new when I bought them! I did enjoy them at the time as they were my first foray into audiophildom. 

I'm pretty sure I did not have the manuals for them and I did bridge them and use them as mono amps. I'm thinking there must have been some type of diagram, so something, on the amp that showed which terminals to use for mono. Is there anything printed on the amp showing mono hookup?

Thanks that what I was told but how is circuit complete without a ground 

And yes there is a diagram that showed to connect to channel a imput.

The directions regarding "connect input to channel A" is referring to your INPUT from your pre-amp. Connect the input from your pre-amp to the channel-A input on each of the two mono amps. Do not use the channel - B input on either of the amps.

You might want to try to reach out to AudiogoN user rwwear. He had a post from a few years ago saying he had a pair of CC-2's he sometimes ran in mono.