Hook-Up Wires for Crossover


I am doing small DIY upgrade to replace stock resistors with
Duelund silver-carbon Cast resistors in crossover of my speakers . Since there is no space on crossover board for large Duelund Resistors , I have to mount them on seperate board and then use individual wires to connect each resistor on to PC board . When I checked internal hook-up wires in my speakers , from crossover to drivers , they are Siltech M20 G7 Silver-Gold wires (1% Gold used in alloy ) . They are 17 AWG thickness.
My questions are:
1)what wire should I use to join Duelund resistors to points on crossover ?
2) Must I use same Siltech M20G7 of 17 AWG ? (I suppose they will be too heavy - around 1.5 mm thick and also very expensive ! ) . Or can I use 20 AWG wire?
3) Can I use Mundorf or DH Lab Silver-Gold wire of 1 mm or 0.5 mm thickness?
4)Is it ok to use different makes of internal wires within a speaker ?
Total wire required is 10 to 12 meters , and such silver -gold wire cost quite a bit , especially if they are 17 AWG or 1.5 mm.
your suggestions and views will be welcome.
Thanks
radni
Hi Radni,

I have used the Mundorf Supreme caps in my DS Xover upgrade and extremely happy with this decision. You cannot go wrong with these and Chris Johnson from PartsConnexion will help you out with your other queries.
I asked Chris Johnson at Parts Connexion about his opinion. I said my options are Mundorf , Duelund and DH Lab . Within hours he replied " if you are trying to match tonal characteristics of Siltech M20G7 , then Mundorf is your best bet ,.... Without a doubt ! "
Considering views expressed here in this thread ,
I think I will go for Mundorf 1.0 mm
Thank you all guys for such involvement and helping me to make a decision . It gives me great satisfaction that this choice is backed by views and opinions of many experts here . This has proved to be a great forum again .
Sharad
I've been tried mundorf silver gold wire and neotech upocc silver wire for hook up, I prefered neotech for more open and dynamic than mundorf
I used Mundorf silver gold alloy wire on my cross over for installing Duelund resistors . They work great for me .