High End Isolation - HRS, SRA, Active platforms

Add Critical Mass platforms to your inquiry.

The Copulare equipment racks are considered exotic and have a nice system to isolate vibrations using lead/sand wooden filled platforms and the base of the racks filled with the same thing. You can customize the fills with quartz sand, lead sand or some other stuff. Their new Coral series have received a lot of attention lately.

http://www.copulare.de/english/produkte/grand_port.htm
Ciao,
Audioquest4life

I have one Halcyonics platform and two Critical Mass Grand Masters. RTNL -- In answer to your question about stacking components on the Halcyonics platform, it depends. The Halcyonics Micro 40 will hold 100 kilograms (about 220 lb), however, you don't want whatever stack you create to be too tall. I am stacking two components with a total height of about 12 to 14 inches and haven't had any problems, but a taller stack (which I have tried) creates sort of a vertical cantilever effect which (particularly if the components are heavy) if bumped, can cause everything to oscillate while the platform tries to regain control of the mass.

In the case I tried, I was attempting to put a lightweight rack on top of the Halcyonics platform and then add components to the rack. It was just too tall.

Having said all that, IMO there is no better isolation platform extant than the Halcyonics.

I have never used an active platform device. Having read some descriptions of such, I have a few questions. What is the bandwidth and reactance speed of the Halcyonics?
How does a platform mechanism such as this deal with self induced vibration internal to the device its trying to protect? Would not stacking more than one electromechanical device on a platform change the inneraction and transfer function of the platform. The reactance time of the platform is going to vary based on the mass and the horizontal movement as well as the center of gravity to all supported components. Tom

I hope an engineer can chime in here, but I'll take a shot at this. A rack really will only deal with vibrations that come through the floor. These are traveling through concrete or wood, and are low frequency. I personally do not see how any rack could effectively reduce air-borne vibrations which are much more brief and of higher frequency.

The active platform will automatically level the platform, and adjust for the center of gravity at the beginning. Sensors will continually monitor the motion to mathematically model the vibrations. It will then create a counter-reaction to bring the platform to rest. Based upon some graphs on the website, it appears that the system will react as soon as the first wave hits, and can settle the platform within a few tenths of a second. This is in contrast to a passive system where the vibration would continue for over a second before coming to rest. All of this depends upon very responsive sensors which are continuously modeling the behavior of the platform in all directions. The concept of halting a resonance in a single direction seems easy to grasp, but it's quite amazing that this can be integrated in 6 different directions with relative speed.

Self-induced vibrations should be effectively controlled as well. This should include spinning platters and humming transformers. Anything that alters the center of gravity or the absolute weight, such as moving the component or opening the drawer, would require the equipment to take a second to automatically relevel and compensate.

The website has some technical papers and graphs that will give an idea of the speed and frequencies involved.