Goertz MI2 with Sim I-5

If your amp was oscillating it would probably go into thermal shutdown in the first few minutes.

This is not true. Some amps / circuits can become marginally unstable yet not break into full blown oscillation. Performance is degraded and the circuit will VERY gradually break down. Full blown oscillation causes much more obvious degradation and would result in a much quicker death.

As to the sound of the system, what kind of results are you getting on other recordings ? Try some male and/or female vocals accompanied by an acoustic based band, some piano recordings, etc... Mix it up as much as possible. I would not base my opinion of a component or cable on one "strange" or "different" result. Sean
>

I've used the MI-2 with my I-5, but with the zobels in place. I remember I didn't have them at first and the amp didn't really get hot, just lukewarm at most. I would put the zobels in just in case, they don't do anything to the sound and they will make sure no oscillation occurs. What's the rest of your equipment?
-Steve

Thanks for your reply.

I mostly listen late 19th century classical music like Mahler, Wagner, and Strauss.

When I play male/female vocal, it sounds like little echoes follow their voices.

Since my amp runs warmer than before, I may need Zobel network.

Here is another question.
Does anyone know how to find R and C values in Zobel network?

Steve
I have resolution CD55, Gyrodec SE+SME309+Audio technica OC-9, Sim I-5 with Dynaudio Contour 1.8MK2.
I use Allen Wright's silver interconnector(you can find his receipe from www.vacuumstate.com) and powercable.

Before I use Goertz, I thought Sim I-5 wasn't enough to drive 87db 4Ohm speaker and considered to move up Sim pre/power combination.
I was just luck to find the weakest link in my system without wasting money and time.

If your amp is running noticeably warmer, you do need the zobels. I would refrain from running the amp with the Goertz until you can install the appropriate impedance networks to take care of this problem. In the meantime, go back to using your older cables and see how they compare now that you've gotten used to the Goertz somewhat. This is not to say that you've heard your system with the Goertz running at optimum performance as of yet though.

The zobel's should be available from the dealer that you purchased them from ( if you bought new ) or directly from Goertz at a very nominal charge if you bought used.

As to the "echo's" that you're hearing, it is possible that you are now hearing the reverb that was originally added to the recording. This is VERY common, as it helps to fill out a voice and add "body" ( if properly used ) while somewhat helping to cover flaws in the vocal performance.

From your comments, it seems as if you've got more apparent volume with the Goertz than what you previously had with another cable. Am i reading that correctly ? Sean
>