Enigma Subwoofer 1980s


I was given a subwoofer that I was told came from the 1980s. It is called an Enigma Subwoofer. The subwoofer comprises 4 woofers mounted in a 2x2 array. There is no cabinet/enclosure around the back side of the speaker (finite baffle).

I believe it once included a controller which I do not have (probably a low pass filter/limiter).

Has anyone heard this subwoofer or know anything about the company that made it? If so, I would appreciate any feedback on the quality of the speaker/sound quality. If this was a reasonable speaker I might want to try to use it. My concern would be damaging the speaker by overdriving it. Would anyone know the amount of power it could handle? I would probably limit the frequency below 80Hz. I would also probably try to use an equalizer on it.

Thank you very much for any input you can give me.
Regards,
Gary
gwho
I have the entire system – (array,amp and controller) utterly fantastic -- no booming just pure unmitigated pure base -- the woofer with its 4x15 inch drivers should be positioned about 18 inches in front of the full range speakers -- on choral pieces it is absolutely stunning. The power and controller sections are in for check up now as is the array being inspected for integrity of the cones. This was a find – purchased in the late 80”s used. Few were produced and rumor is that they were in the $8k range back in the late 70's early 80's – it is large standing on pylons floor to top 46 inches high – array is 34x34 x8inches –power amp and controller separate units well over 45lbs. Would like to find schematics for my techs. The combination of this unit with valve pre and amp plus the floor standing ProAch’s and Von Schweikert S1 produces an amazing sound environment. I will repost any technical information assembled after the tune up on this site for anyone fortunate enough to have discovered one of these monsters!
THS 10/11/13 -- csynergy10@aol.com
There is almost no information on this device out there. I did find out that it retailed for 2295.00 back in the 80s which means it was a high end piece. It could also get down to 20hz. I also wish I had a schematic also. I have removed the cloth from mine as I thought the speakers had an issue. As it turns out the speakers are in great shape still with good foam surrounds. My controller functions intermittently so I don't use it now. I agree with you. When it was working it could definitely put out the bass. Dipole subwoofer sounds different than a box subwoofer.

Have your tech put a signal generator to the electronic equalizer. It would be very valuable if your tech can find out the following:
1. what frequency does the 18db/octave low pass kick in.
2. what frequency does the 18db/octave (or 6db/octave) high pass kick in.
3. resonant frequency of the woofer
4. most critical is to understand at what frequency the 6db boost occurs to compensate for the open baffle dipole fall off.

The woofers are custom designs with an xmax of 1". The Enigma was ahead of its time!

Let me know if you find this info as I would like to restore my enigma.

Congrats on a great find.

gwho

Several years ago I posted regarding my Enigma powered by the Hafler 909 and a Crossover unit.  The Amp checked out last week and the crossover which allows the system to function had two bad chips with all identification scratched off (reason the last repair crew gave up) 

It was reversed engineered and this coming week I will pick up apparently fully restored. 

Accordingly will post all information gleaned in restoration and an evaluation as to the sound and adequacy of the base -- who knows --  has sat in my living room for the last decade or so untouched.   If working will report and provide information on company that performed the reverse engineering etc. 

THS

04-08-2023

All I remember is that it was not the sound but the realization that my tie was fluttering behind my neck straight out when the sub was engaged!  And my neighbors dentures were ratteling inshide his head.