2. analog
  3. 1341804352

Don't use this to lube your VPI Classic bearing

I recently lubricated the bearing on my Classic using white lithium grease purchased from ACE Hardware. The brand is AGS; it came in a white 1.25 oz tube. After about a week, I heard a whooshing sound coming from (under) the platter at each spin. I removed the platter and the sight was not pretty - some of the grease turned into a gooey brown substance and pooled at the bottom of the shaft; there were some chunks of the grease inside the hollow. I didn't use that much of it and it looked worse than after a full year of use with the original job performed by VPI.

I cleaned it all out, and the whooshing sound went away. So if your Classic is due for maintenance, stay away from this particular product.

Does any Classic owner have a brand/product they can recommend for lubricating the bearing? Considering that you only need a little bit of it about once a year, $26 for the lube from VPI is a bit steep.
actusreus
actusreus OP
733 posts
 
So I finally lubricated my Classic with this particular grease that was ok'ed by VPI. I found it quite thick and not slippery, almost like toothpaste. But what do I know; after all, it has Teflon in it, which is one of the most slippery substances known to man...

Well, I started listening earlier today and actually heard the pitch was off on a U2 album. My SDS was set to 60.20 Hz. When I checked the speed with the KAB strobe, the platter was spinning way too slow. I had to go up to 61.85 Hz to get the speed dead on. So what the hell? That can't be right. If I didn't have the SDS, I could not listen to without removing the grease. I find this extremely frustrating as this should be a simple maintenance job that turned into a major headache.
slaw's avatar
slaw
21,770 posts
 
I use Permatex white lithium grease from a major auto parts retailer. The OCD in me says, check this out, however, I've not noticed any noises in over a year ( I use a HW-19MkIV w/non-inverted bearing/w/ceramic bearing,SDS, so I think I'm fine. I know it's expensive, but I invested in a Sutherland Timeline and have never regreted it. I know from what I've read that the Classic has good speed stability, IMO, if you're MAJOR into analog, get a Timeline. It will/should rock your world.
darrylhopkins
2 posts
 
Hello, I'm bumping this old thread. I have a Classic 1 and want to make sure I'm using the correct Super Lube, as there seem to be several varieties. I see this one at Amazon for $5.21. Is this the one that I should use? Thank you.

Super Lube Synthetic Grease with Syncolon Multi Purpose Lubricant 3 oz

http://amzn.com/B000XBH9HI

Description: "Super Lube Grease is a patented synthetic, multi-purpose lubricant with Syncolon (PTFE). Synthetic base fluids and the addition of PTFE micro powders combine to form a premium lubricant that provides protection against friction, wear, rust and corrosion over a temperature range of -45°F to +450°F. Super Lube Grease is a USDA/NSF listed Food Grade lubricant NLGI-2, rated H-1 for incidental food contact, and will not run, drip, melt or separate. Compatible with most other lubricants, Super Lube outlasts conventional greases 3–4 times."
More to discover