Disassembling BlueSound Node 2i?


I'm evaluating whether to replace the hated RCA s/pdif output with a proper 75 ohm BNC socket. The Node 2i doesn't seem to be held together by screws, rather it's apparently a snap-fit case on the chassis. Has anybody taken one of these apart? If so any tips? Thanks,
raueda1
But are there audible shortcomings that I'm going to hear in my systems? Doing a comparison is obviously very hard. And the audibility would certainly depend on the system and source. I'd be amazed if it were audible on a mid-level system streaming Spotify. But playing through a truly high end DAC into a very resolving system? Well, maybe. OTOH, maybe the Node 2i isn't resolving enough to tell the difference in >>any<< system anyway.
And that was more the point I was trying to make tbh.
However as a member above has posted, you maybe able to get into it and then you maybe able to change out the RCA output socket indeed.
Good luck!
Basically there are 2 caps next to a heat sink (this unit runs very warm anyway) that have failed.  I am going to try to take this to a local repair shop and let you know what I find.