Per Dougdeacons suggestion I tried the parasound phono stage and absolutely noticed a difference but not for the better. The bass was smeared and diffuse and their was a not so pleasant high pass effect that seemed to take the sizzle out of the cymbals. I will revert back to the internal Marantz pm7200 phono stage for now. However, my next question is to change out the cartridge for something more detailed with a tight bottom end, wide sound stage, and a lot of high hat sizzle and definition. I would like any suggestions in the the not to exceed $100.00 dollar range. This is the only upgrade I am going to be looking at as next end of year 2014 I will upgrade my entire turntable and pre.
Desire upgrade but uncertain where to begin
I have a Project Debut 2 table with a Grado black or red, uncertain. This is currently connected to my Mrantz pm 7200 with internal phono stage. I have a parasound pph-100 that I can hook up but wanted some clarity before I continue. These are output to Cambridge Soundworks Kloss Tower II speakers. Wanted to optimize my analog front end and wanted help deciding if I should move my phono stage to the parasound, and/or get a new cartrige or table. I have entry level budget but just wanted some comments and opinions about best place to start to improve sound. Current set up has narrow sound stage yet warm and detailed. There is an adequate tight bottom end but the top is a bit subdued--cymbals need more detail at the top end. Any comments about alternate analog front end would be great.
- ...
- 10 posts total
- 10 posts total